[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [AUCTeX] Refering to figures in \inputed files
From: |
Andersson, Henrik |
Subject: |
RE: [AUCTeX] Refering to figures in \inputed files |
Date: |
Tue, 1 Nov 2005 13:12:06 +0100 |
> -----Original Message-----
> From: Ralf Angeli [mailto:address@hidden
> Sent: den 1 november 2005 12:05
> To: Andersson, Henrik
> Cc: address@hidden
> Subject: Re: [AUCTeX] Refering to figures in \inputed files
>
> * Henrik Andersson (2005-11-01) writes:
>
> > What do I have to do to be able to refer to labels in \inputed
documents?
> >
> > When I try C-c ) and an appropiate label type, I can only choose
from
> > the labels found in the main file.
>
> Did you follow (info "(reftex)Multifile Documents")?
>
> --
> Ralf
Yes, I did, since it seemed very logical. But no luck...
I have a main file "TeX-master" named identifytracer.tex and below is
the content of one of the inputted files
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
\begin{figure}
\centering
\includegraphics[width=\textwidth]{fig6}
\caption[Sensitivity v.s. time]{The summarized sensitivity based on
$\delta^{msqr}_j$
(Eq.~\ref{eq:msqr}) on the modeled tracer concentration in the
pore-water reaches optimal values at different times. Shallow
and deep refers to the two parameter sets in
Table~\ref{tab:tracer-parameters}. All
functions start at 3 hours, which is considered to be a minimum
time to integrate irregular animal behavior \citep{forster99}.}
\label{fig:senstimeseries}
\end{figure}
%%% Local Variables:
%%% mode: latex
%%% TeX-master: "identifytracer.tex"
%%% End:
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
So, what did I miss?
- Henrik