[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-gcc-list] Programming Circuit for AVRDUDE
From: |
Heiko Rosemann |
Subject: |
Re: [avr-gcc-list] Programming Circuit for AVRDUDE |
Date: |
Sat, 14 Jun 2003 16:31:52 +0200 (CEST) |
Hi there,
On Fri, 13 Jun 2003, Donovan Parks wrote:
> Hello,
>
> My question: is there a simple (i.e. something that could be built on a
> breadboard) programming circuit that can be used to program AVR's. I have
> read through the AVRDUDE manual and it seems promising, but does not contain
> any information on the circuits themselves. Are there major limitations to
> programming AVR's in this manner (as opposed to using an STK500)? What will
> I not be able to do (there is some meantion of certain fuses not being
> accessible in parallel or serial programming modes)?
I really can recommend sp12 for this - 3 Cs, 4 Rs and a crystal on the
parallel port. It works for me quite well, without external power supply.
Check http://www.xs4all.nl/~sbolt/e-spider_prog.html
Of course, as with every serial programmer, you won't be able to set certain
fuse bits on certain AVRs, but isn't the STK500 a serial programmer too? At
least the STK300 was...
HTH, Heiko 'HeRo' Rosemann
--
Alle in dieser Mail vertretenen Meinungen sind meine eigenen, soweit nicht
besonders gekennzeichnet.
- Re: [avr-gcc-list] Unused registers saves/restores ?, (continued)
Re: [avr-gcc-list] Unused registers saves/restores ?, E. Weddington, 2003/06/09