Re: [avr-gcc-list] SPI problem

[Jack Valmadre]

The LED should stay on until the power is cut or the micro is reset.
Jack


----- Original Message ----- 
From: "Rick Mann" <address@hidden>
To: <address@hidden>
Sent: Thursday, August 19, 2004 12:34 PM
Subject: Re: [avr-gcc-list] SPI problem


> 
> On Aug 18, 2004, at 16:52, Jack Valmadre wrote:
> 
> > I have an LED attached to pin 5 on port D, but the LED does not light 
> > up, so
> > the program doesn't seem to make it past the second transmit.
> 
> If the line isn't going high (or low) for very long, then you'll never 
> see the LED light up. You should check with an oscilloscope.
> 
> -- 
> Rick
> 
> 
> _______________________________________________
> avr-gcc-list mailing list
> address@hidden
> http://www.avr1.org/mailman/listinfo/avr-gcc-list