Re: [avr-gcc-list] programming SOIC devices.

[Neil Davey]

Hi Mitchell,
I have, or had, the same problem as you for some projects I'm working on...
The solution I use is a soic test clip, wired up to the ISP header on 
the STK500 works a treat.

Or you can use a soic zif socket wired up to the ISP header...
Takes a little fiddling to set it all up, but once done it's all sweet..

Regards
Neil Davey

address@hidden wrote:

> Hi,
> This is a little off subject but somebody on this list should have an
> opinion.
>
> I need to program some ATtiny45V in SOIC form factor prior to them being
> put on a PCB. I have an AVR STK 500 which of course takes DIPs.  I am
> looking for an adapter that would work with the AVR STK 500 for
> programing 8 pin SOICs.
>
> Mitchell James
>
>
> _______________________________________________
> AVR-GCC-list mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/avr-gcc-list
>
>  


--
--------------------------------------
Neil Davey
Griffith University

School of Microelectronic Engineering
Nathan Campus
Phone: 07-3735-7008
Fax: 07-3735-5112

School of Psychology - ACNRC
Mt Gravatt Campus
Phone: 07-3735-3395
--------------------------------------