Does anyone have a good debug method for figuring out why
my ATMega16 is resetting while my application is running (a robot). I can
get 20-30 seconds of run when it is driving but then I get a reset (I have radio
communications over serial so I can see the startup banner go by again). I can
then send another run command but it resets again shortly (repeat this cycle at
will).
No watchdog, I have the brown out set at 2.7vdc
(and off). This runs as long as I want on the bench but put it in the
field and I get the resets.
avr-gcc (GCC)
3.4.3 WinAvr.
David
|