[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within amulti-by
From: |
Vincent Trouilliez |
Subject: |
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within amulti-byte integer ? |
Date: |
Sat, 05 Nov 2005 01:23:28 +0100 |
> For a long time I always put address bit 0 on address pin A0 of the
> memory,
> bit 1 on A1, etc. But this is not always needed! Especially for a RAM
> device where you the AVR is the only one having access, the address
> lines
> can be swapped as you like. The same holds for the data lines. For ROM
> memory
> I have use this as well to enable better PCB routing and just swapped
> the contents
> before flashing.
> but I found it a nice extra design parameter I could play with.
>
> Regards,
> Martijn.
Interesting, thanks :o)
--
Vince
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within a multi-byte integer ?, Bernard Fouché, 2005/11/04
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within a multi-byte integer ?, Bernard Fouché, 2005/11/04
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within a multi-byte integer ?, Vincent Trouilliez, 2005/11/05
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within a multi-byte integer ?, David Kelly, 2005/11/05
RE: [avr-gcc-list] How to (efficeiently !!!) test a bit within amulti-byte integer ?, Niklas Lövgren, 2005/11/05
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within amulti-byte integer ?, Eric Weddington, 2005/11/08
RE: [avr-gcc-list] How to (efficeiently !!!) test a bit withinamulti-byte integer ?, Niklas Lövgren, 2005/11/09
Re: [avr-gcc-list] How to (efficeiently !!!) test a bit within a multi-byte integer ?, David Kelly, 2005/11/04