Re: [avrdude-dev] Calibration bytes on ATmega8

[Brian Dean]

On Tue, May 06, 2003 at 05:40:13PM -0300, Francisco T. A. Silva wrote:

> The Atmega8 has 4 calibration bytes. The atttached patch makes it 
> possible for avrdude to read them all.

The data sheet speaks only of a single calibration byte.  If you can
show where this is documented somewhere in the datasheet or perhaps in
an errata somewhere, I have no problem adding this to the
configuration.  However, I don't think it's wise to deviate from the
documented data sheets too much.  For example, even if this works for
some parts, since it's not documented in the data sheet Atmel is free
to change the behaviour at any time, and we probably should not rely
on it being there.

-Brian
-- 
Brian Dean
address@hidden
http://www.bsdhome.com/
http://www.bdmicro.com/