Re: [avrdude-dev] JTAGICE MKII very slow under Ubuntu Linux 9.04

[Markus Schulz]

I just want to give a little update so you can concentrate on the real
issues, the slow programming.

With the new 5.8 version it is now 95s, but on windows it is still only
~5s... any idea why so slow? By the way I tried to connect the reset to
ground, but this doesn't make it faster.

By reading through this mailing list I was able to compile 5.8 version
now, looks like I was missing flex package as well... so I did a:
sudo apt-get install flex byacc bison

If I don't use the -D I still get this error
(RSP_ILLEGAL_EMULATOR_MODE)? I guess I also had this in 5.6, but without
displaying the message. Because I was never able to use the program
without -D... should this work?

Regards,
Markus

PS: sorry for the double post...

address@hidden:~/avr/HIDKeys.2007-03-29_change$ make flash
avrdude -s -U HIDKeys.hex -c jtag2isp -p 2313 -P usb -D

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.15s

avrdude: Device signature = 0x1e9101
avrdude: current erase-rewrite cycle count is 2147483647 (if being tracked)
avrdude: reading input file "HIDKeys.hex"
avrdude: input file HIDKeys.hex auto detected as Intel Hex
avrdude: writing flash (1866 bytes):

Writing | ################################################## | 100% 95.22s

avrdude: 1866 bytes of flash written
avrdude: verifying flash memory against HIDKeys.hex:
avrdude: load data flash data from input file HIDKeys.hex:
avrdude: input file HIDKeys.hex auto detected as Intel Hex
avrdude: input file HIDKeys.hex contains 1866 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 95.21s

avrdude: verifying ...
avrdude: 1866 bytes of flash verified
avrdude: jtagmkII_close(): bad response to GO command:
RSP_ILLEGAL_EMULATOR_MODE

avrdude done.  Thank you.


> Here is my console output
> 
> address@hidden:~/avr/HIDKeys.2007-03-29_change$ avrdude -U HIDKeys.hex -c
> jtag2isp -p 2313 -P usb -D
> 
> avrdude: AVR device initialized and ready to accept instructions
> 
> Reading | ################################################## | 100% 0.15s
> 
> avrdude: Device signature = 0x1e9101
> avrdude: current erase-rewrite cycle count is 2147483647 (if being tracked)
> avrdude: reading input file "HIDKeys.hex"
> avrdude: input file HIDKeys.hex auto detected as Intel Hex
> avrdude: writing flash (1866 bytes):
> 
> Writing | ################################################## | 100% 284.16s
> 
> avrdude: 1866 bytes of flash written
> avrdude: verifying flash memory against HIDKeys.hex:
> avrdude: load data flash data from input file HIDKeys.hex:
> avrdude: input file HIDKeys.hex auto detected as Intel Hex
> avrdude: input file HIDKeys.hex contains 1866 bytes
> avrdude: reading on-chip flash data:
> 
> Reading | ################################################## | 100% 95.08s
> 
> avrdude: verifying ...
> avrdude: 1866 bytes of flash verified
> 
> avrdude done.  Thank you.