[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Distributed.Net Block Fetcher Failure
From: |
blocks-bounces |
Subject: |
Distributed.Net Block Fetcher Failure |
Date: |
15 Apr 2004 14:26:07 -0000 |
A complete request was not found. At the very minimum, your
request should specify the number of blocks that you would like,
via the 'numblocks' keyword.
INSTRUCTIONS FOLLOW:
This message has been sent to you because you sent mail to
address@hidden The attached is the output of "dnetc -fetch".
Include "numblocks=yyyy" anywhere in the body of your message. Note
that the client may impose an upper-limit of the number of workunits
you can request at a time.
To request OGR blocks compatible with the new v2.9 clients, include
"contest=OGR" anywhere in the body of your message. To request OGR
blocks compatible with the older v2.8 clients, include
"contest=OGROLD" instead. The default is to request RC5-72 blocks
(which are only usable by v2.9 clients).
Other than these flags, the contents of any messages sent to
address@hidden are ignored.
Three "-fetch" attempts are made, in an attempt to overcome any
network errors.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- Distributed.Net Block Fetcher Failure,
blocks-bounces <=