Schematic Library compatibility problem

[Richard Griffith]

Hello,

I have circuits that have migrated through several versions of electric 
and been imported from Cadence through and EDIF process. This involved 
scaling and different technologies in Electric.

I now have a library that was done with Electric 8.01 on another 
computer and it loads fine and netlists/simulates on that machine.
Loading it into my library set with Electric 8.01 I get a small error.
I correct the error. Save the library, restart electric, reload the 
library set and I get new errors.
I correct the errors. Save the library, restart electric, reload the 
library set and I get new errors.
repeat.

I suspect this is due to different scaling between the original library 
set and my current set and arcs, pins not connecting with my current 
options. But I wonder why I get new errors when I save it from my 
current session.

I can also open the library in Electric 8.02. I get another single small 
error.
Cell xxxx has an unconnected pin
That pin is available in the selection list. When I select that pin and 
Focus on Highlighted to find it a memory leak is exercised and what was 
once a happy 200M process uses my entire system page file allocation.


I am wondering if anyone has seen the scaling issue and has a solution 
other than redrawing the entire library.

Also I would like hints at how to get an example error rather than my 
entire design library set so I can submit a bug report.


Regards,
Richard Griffith.