Ok, adding instructions:
1. Create the following file as "buginit.el" (or whatever you want to
call it):
(setq package-archives '(("gnu" . "http://elpa.gnu.org/packages/")
("melpa" . "http://melpa.milkbox.net/packages/")
))
(setq user-emacs-directory "~/bug.emacs") ; just to get a clean user dir
(setq package-enable-at-startup nil)
(package-initialize)
(require 'helm-config)
(projectile-global-mode)
(setq projectile-enable-caching t)
(setq projectile-completion-system 'helm)
(helm-projectile-on)
2. Run emacs: emacs -Q -l buginit.el
Install Helm Projectile:
(alternatively I can supply all the files for the elpa folder in the
bug.emacs in a file drop somewhere)
3. M-x package-install
4. When it asks what to install, use "helm-projectile"
5. Quit emacs.
6. Run emacs again: emacs -Q -l buginit.el
7. Find a sufficiently large project, I am not sure exactly what makes
the project big enough (or if there is something else like large file
names or deep directory structure), however the Emacs codebase is not
sufficient. A project i can always repro with can be retrieved with:
git clone https://github.com/forcedotcom/aura.git
8. Open a file in the Aura project, any file will do (LICENSE, for
example). In emacs, C-x f ~/path_to_aura/LICENSE
9. Open the helm-projectile minibuffer: C-c p f
or M-x helm-projectile-find-file
10. Start typing: I find "infiniteScrollerTest" should cause it to
break and produce extra characters.
Hope this is helpful!
-g
(second sending-- did not reply to debbugs.gnu.org <http://debbugs.gnu.org>)
On Thu, Jan 8, 2015 at 10:22 PM, Jan D. <jan.h.d@swipnet.se
<mailto:jan.h.d@swipnet.se>> wrote:
Greg Smolyn skrev den 2015-01-08 20:09:
If you look at the repro in #18345, it is the same scenario when
Simon
Carter removed the emacs_abort() in the apploopnr > 1 check. I get
extra characters in the input.
There was no step by step instructions there either.
Should I perhaps reopen that bug instead?
This is fone.
Unfortunately I don't know entirely how to do this without helm
projectile. Would you like me to send instructions on how to
set it up
for a reproduction case? I am more than happy to do that.
Put the instructions here where they belong.
It is good for future reference.
Jan D.