[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
bug#19248: installation of 0.8 stops at guile prompt.
From: |
Ludovic Courtès |
Subject: |
bug#19248: installation of 0.8 stops at guile prompt. |
Date: |
Fri, 12 Dec 2014 23:01:30 +0100 |
User-agent: |
Gnus/5.13 (Gnus v5.13) Emacs/24.4 (gnu/linux) |
kennedy <address@hidden> skribis:
> address@hidden (Ludovic Courtès) writes:
>> th3kent <address@hidden> skribis:
>>> address@hidden (Ludovic Courtès) writes:
>>>> [...]
>>>> Could you post your OS config?
>>> (initrd (lambda (file-systems . rest)
>>> (apply base-initrd file-systems
>>> #:extra-modules '("pata_acpi.ko" "pata_atiixp.ko")
>>> rest)))
>>
>> This may be the culprit. First, it’s not needed, because 0.8 already
>> included these two modules by default. Second, 0.8 would fail when
>> trying to load the same module twice, which is exactly what would happen
>> here (this is fixed in ‘master’, around commit 0e704a2.)
>>
>> Could you try to remove these ‘initrd’ lines and try again?
>
> i deleted the lines for "initrd" and the installation completed
> successfully on first attempt.
So you booted on the USB disk and re-run ‘guix system init’, is that
correct?
Did you reformat the root partition before doing that?
> however, the reboot after installation results in a kernel panic. the
> messages just before the panic are the following,
>
> groupadd: cannot lock /etc/group; try again later
Could you try removing the /etc/.pwd.lock file on that partition? (You
can do that on a system booted from the USB stick, and then reboot in
the installed system.)
Thanks,
Ludo’.