Re: print does not work under 1.4.8?

[Andrew Clausen]

address@hidden wrote:
> 
> I have an ext2 file system on a 1.2G drive which I would like to shrink down 
> to 900M so that I can add a boot partition to the drive (and thereby restore 
> the system).
> When using parted 1.4.8 the print command gives me:
> Minor   Start      End      Filesystem  Flags
> 1     0.000 12419.056   Ext2
> 
> When I do a resize the system gets busy for a bit and then simply comes back 
> to a command prompt leading me to believe that the FS really has been 
> resized.  However the print command still shows the same size.
> 
> What gives?
> 
> As an experiment I statically linked ext2resize and used it to resize the 
> partition down to 900M.  The same thing happens.  The command is obviously 
> doing something and does not report anything wrong.  However parted print 
> still shows a size of 12419...

What did you type, to start Parted?  Can you show me the ENTIRE output
of the print command?

Thanks,
Andrew Clausen