[Denemo-devel] Playback of selection

[Richard Shann]

On Fri, 2007-12-14 at 15:13 +0000, Richard Shann wrote:

> While working on the print command I noticed it would be easy to make
> the Play command play the current selection (if there is one) rather
> than the whole piece. This would be much more convenient to spot check,
> say, the current measure rather than going through the playback
> properties dialog. I'll work on this.

I've checked in this - it means that if you hear a wrong note during
playback you can go to the measure, click to select and play and get
just that measure played back. As well as playing larger selections of
course. It would be possible to playback just the notes selected ...
Of course, if you want the whole piece, you just click to get no
selection and then Play.
If it is not in the documentation, we should point out that you can
interrupt the Play at any time by pressing Play again (it would be nice
to change the Play to a Stop, but not trivial)
Richard