Re: [Denemo-devel] Some glitches

[Bric]

> On February 4, 2018 at 12:39 PM Richard Shann wrote:
>
>
> On Sun, 2018-02-04 at 11:52 -0500, Bric wrote:
> > > > Copied over a sync'ed pair from Windows, and ran the Ubuntu
> > > > denemo - 
> > > > segfaults at the same stage
> > > This becomes interesting - can you email your Default.commands,
> > > Default.shortcuts files and I can look at what may be going on
> > The attached files are the windows defaults i tried to impose on my
> > new Ubuntu build, that led to the crash.
>
> Your Default.commands is faulty. As you haven't created any custom
> commands you can copy the Default.commands from the installation (or
> git ...) into your .denemo-2.2.?/actions directory to replace the one
> you took from your Windows installation. That works fine with your
> Default.shortcuts (giving for example, Ctrl-Shift-2 for insert duplet).
>
> I've pushed an refinement to the code so that it will not crash with
> that sort of erroneous Default.commands (I suspect the fault may arise
> because windows paths don't start with a \, but I'm not sure)

Yay! that worked !

I should note, though, that "make install" did not place "Default.commands" in my ~/.denemo-2.2.1/actions$ directory (nor Default.shortcuts)

And, apparently, "Default.commands" is needed to load "Default.shortcuts" (?)

So... I initially copied over just "Default.shortcuts", and observed the old shortcuts do not get loaded (just confirmed this again two minutes ago).  Then I copied over the "Default.commands" - and observed the segfault.

All is well that ends well. Thanks.

> Richard