[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
How to add bus exports in Layout view.
From: |
Kurt Landrus |
Subject: |
How to add bus exports in Layout view. |
Date: |
Fri, 19 Jan 2007 16:29:13 -0600 |
How do you add bus exports in a layout view so that they will match
up with the
bus definitions in the schematic when running NCC?
here is the results of the summerize exports on a cell for both the
schematic and layout views, The cell fails NCC, and I don't know how
to label the input ports on the layout so that they match the bus
port in the schematic.
=================================1179=================================
----- Exports on cell 'ALU_Control{lay}' -----
Input ports 'Op[0,1,2]' at (-160.0<=X<=-160.0, -64.0<=Y<=-50.0), same
bus,
connects to Metal-1
Output export 'Cin' at (77.0, 55.0) connects to Metal-1, Metal-2
Output ports 'G[0,1,2,3,4,5,6,7]' at (102.0<=X<=643.0,
55.0<=Y<=63.5), same bus,
connects to Metal-1, Metal-2
Power export 'vdd' at (-156.0, 32.5) connects to Metal-1
Ground export 'gnd' at (-158.0, -37.5) connects to Metal-1
=================================1180=================================
----- Exports on cell 'ALU_Control{sch}' -----
Input export 'Op[2:0]' at (-50.0, 28.0) connects to wire, bus
Output export 'Cin' at (40.0, 6.0) connects to wire, bus
Output export 'G[0:7]' at (52.0, -66.0) connects to wire, bus
- How to add bus exports in Layout view.,
Kurt Landrus <=