[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Problem using the dbs card
From: |
Krzysztof Kamieniecki |
Subject: |
Re: [Discuss-gnuradio] Problem using the dbs card |
Date: |
Wed, 12 Oct 2005 21:06:56 -0400 |
User-agent: |
Mozilla/5.0 (Windows; U; Windows NT 5.0; en-US; rv:1.7.8) Gecko/20050511 |
Hi Frederic,
Where did you get dbs_fft.py from?
I was a bit confused with gnuradio-examples/python/usrp/dbs_debug.py, in that the sliders label RF
and IF gain actually seem to be attenuators. To actually get some signal I had to slide them to the
left.
Regards,
Krys
EVENNOU Frederic RD-TECH-GRE wrote:
Hi everybody,
I started using the gnuradio platform some few weeks ago, and I've been
trying to use the dbs_rx card. I made some few tests to practice myself
on the way to use this card, but unfortunately I didn't have any
successful result.
I've been using a python program named dbs_fft.py to have a look at the
spectrum in a range of frequencies that I specify. I made some few tests
by emitting a sine wave at 1GHz (and then around this frequency), but
I've never been able to get it with the dbs card, whereas I can see it
very clearly on a spectrum analyzer (level == address@hidden). At emission,
and reception, I have some antennas working in that band and antennas
are separated by 50cm. On my display screen I just receive some noise so
I must receive some samples from the dbs_rx card.
I made the same test at lower frequencies and using the TVRx card to
receive the signal, and it works pretty well.
Did someone have the same problem with this card, and is there anything
special that can be done to check if my dbs_rx card works properly ?
Thanks for your help
Frederic
------------------------------------------------------------------------
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
--
Krzysztof Kamieniecki
callsign:KB1KLB
mailto:address@hidden