Re: [Discuss-gnuradio] Signal to Noise Ratio

[Michael Ford]

Eric,

I picked up some of the books, thank you for the reference. After reading them and consulting with my peers, I need to know - is there an RSSI circuit on these boards? I'm using the Flex 2400.

-Michael Ford-

On 6/6/06, Eric Blossom <address@hidden> wrote:

On Tue, Jun 06, 2006 at 04:26:22PM -0500, Michael Ford wrote:
> Hello all,
>
> After getting past my initial assertion error, I've been reading the
> tutorials written by Dawei Shen trying to get a better understanding of the
> code that I'm dealing with. Granted the tutorials are a bit outdated, but
> between them and my existing programming knowledge I've been able to get
> through most of the tutorials. I'm now on the eigth of eleven total.
>
> As I mentioned before, I'm trying to create my own working version of
> CSMA/CA protocol. However, so far, nothing has jumped out at me in the
> tutorials as being able to help me determine the SNR. I'm switching from my
> DSP book (Oppenheim, Schafer and Buck) to the tutorials to wikipedia
> articles in trying to get past this hump by myself, but in the meantime,
> could someone point me in the right direction? I'm expecting to see a
> measurement of decibels somewhere, but it's not happening in the tutorials.
>
> -Michael Ford-

Hi Michael,

Sounds like it's time to switch from the DSP books to the digital comms books ;)
See http://comsec.com/wiki?SuggestedReading for a good selection.

Eric