|
From: | Mark Sullivan |
Subject: | Re: [Discuss-gnuradio] Suse10.1 walkthrough and a question concerning crosstalk |
Date: | Mon, 25 Sep 2006 11:50:51 -0400 |
On Fri, Sep 22, 2006 at 05:38:54PM -0400, Mark Sullivan wrote:
> When I inject a signal at a -45 dBm level on the "RX-B" sma connector on a
> Basic RX daughtercard, I see a copy of the signal on the "RX-A" side when I
> use usrp_fft.py. The level is 10-20 dB below that of what I see if I move
> the signal from "RX-B" to "RX-A," but this seems like too much coupling.
> Using a 50 ohm termination on the unconnected sma connector helps a little
> bit. I see no copy of the signal from either input of the other Basic RX
> daughtercard. Any thoghts, anyone?
>
> Best regards,
>
> Mark Sullivan
Hi Mark,
There's a chance that the code that determines the rx digital mux
setting isn't handling this case properly.
Assuming that the Basic Rx is on the "A" side, please try this:
$ usrp_fft.py -R a:0 -f <freq>
and try moving the test signal from RX-A to RX-B
and this:
$ usrp-fft.py -R a:1 -f <freq>
and move the test signal from RX-A to RX-B
What happens?
Thanks,
Eric
[Prev in Thread] | Current Thread | [Next in Thread] |