On Feb 28, 2007, at 4:29 AM, seph 004 wrote: Well, I have implemented a bit of a strange setup which seems to be working somewhat now. I'm not really trying to view only the first few samples, I'm currently trying to track where I might of made a mistake with trying to generate a defined pulse with a specific length. My aim is to generate a very narrow band chirp to transmit on a little ultrasonic tranducer. I figured out which numerical values to the gr.modulation block produce which frequencies. Using this, I made a vector of the exact number of samples I want with the values to produce the frequencies I want. In my case 39-41 kHz. For some reason these low frequencies still make it through the transformer on the basic TX db, so I'm using them. Initially I was just generating a sine wave, and trying to use gr.head to limit the number of samples, but I've since switched to this approach
I figured that if I wanted to produce a wave form lasting 10 msecs, then I would need at least 2500 samples. I got this number from the DAC rate of 128M and the highest interpolation factor of 512. When I test with the scope set to auto store, I spot the waveform, but it is only 1 msec long. So either I've lost a lot of samples somewhere, or my scaling is wrong.
How are you creating the flow graph? I pretty much abandoned using gr.head, as it wasn't producing anything. At least now though I can see a waveform, though my scaling seems to have gone wrong somewhere. When you say you used a looback, do you mean you connected the TX db output and RX db input, and used the gr.oscope block to view your signals? Regards Lance ----- Original Message ---- From: Lee Patton < address@hidden> To: seph 004 < address@hidden> Cc: address@hiddenSent: Tuesday, February 27, 2007 12:58:31 AM Subject: Re: [Discuss-gnuradio] The shortest pulse length On Mon, 2007-02-26 at 00:55 -0800, seph 004 wrote:
> I have a vector source producing a sine wave, and then I'm using > gr.head to limit the number of samples sent.
I'm sure you checked this, but are you trying to capture the first few samples of sin(x)? I so, sin(x) = x for small angles, and sin(0)=0. So, you won't see anything in the first few samples anyway.
> From your explanation, I should be ok with even a low number of > samples. When I tested my setup, I couldn't catch anything on the > scope. There is probably some problem in how I made the app. > > I saw something mentioned elsewhere in the discussion archives that > the usrp dumps the first few samples it receives from the host before > transmitting. Is this still something to take note of?
I don't know whether or not the USRP dumps the first few samples. I don't think I've ever experienced it though. I can say that there is an unpredictable delay from the generation of the first sample in software until the time it actually reaches the output port.
I haven't tried to do what you're doing -- i.e., capture the first few output samples on a scope. How is the scope triggered? (What I did was create a loopback whereby I transmit and receive by reading the bleedover on the daugherboard.)
-Lee
Now that's room service! Choose from over 150,000 hotels in 45,000 destinations on Yahoo! Travel to find your fit._______________________________________________ Discuss-gnuradio mailing list
|