discuss-gnuradio
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[Discuss-gnuradio] Help with Usrp Board test
From
:
Melody S
Subject
:
[Discuss-gnuradio] Help with Usrp Board test
Date
:
Fri, 4 May 2007 11:57:55 -0700
Hi,
I am trying to test my Usrp board, but there are two problems,
1 ) I have downloaded and install the gnuradio from Subversion and as long as I look through the usrp/share/rev2, I have the files
multi_2rxhb_2tx.rbf
std_2rxhb_2tx.rbf
std_4rx_0tx.rbf
std.ihx
and I don't have the files usrp_firmware.ihx and usrp_fpga.rbf
should I download them and install or this is because of subversion?
2) Also when I try to run this command
./test_usrp_standard_tx
I get the following errors
usb_control_msg failed: usb_control_msg(DeviceRequestTO): pipe is stalled
usb_control_msg failed: usb_control_msg(DeviceRequestTO): pipe is stalled
xfered 1.34e+08 bytes in 4.2 seconds. 3.194e+07 bytes/sec. cpu time = 0.71
0 underruns
Does this mean that I don't have the right USB or it is because I don't have the necessary files that I mentioned in question 1.
Appreciated for your help.
Melody
reply via email to
[Prev in Thread]
Current Thread
[
Next in Thread
]
[Discuss-gnuradio] Help with Usrp Board test
,
Melody S
<=
Re: [Discuss-gnuradio] Help with Usrp Board test
,
Michael Dickens
,
2007/05/04
Re: [Discuss-gnuradio] Help with Usrp Board test
,
Eric Blossom
,
2007/05/04
Prev by Date:
[Discuss-gnuradio] USRP Rev3 Schematic and external clock
Next by Date:
Re: [Discuss-gnuradio] Help with Usrp Board test
Previous by thread:
[Discuss-gnuradio] USRP Rev3 Schematic and external clock
Next by thread:
Re: [Discuss-gnuradio] Help with Usrp Board test
Index(es):
Date
Thread