Re: [Discuss-gnuradio] wxPython 2.8.8.0 and cygwin installation failure

[Michael S. Grant]

Hello, Nagaraj,

Thanks very much for this information - I had not thought of trying the
earlier version of swig 1.3.31.  I have searched for wxPython 2.8.7.1 but
have, so far, only found 2.8.8.0 (but I'll find the earlier version
somewhere!)

Best regards,

Michael



> Michael,
>
> Even I had a similar problem. When I reverted back to wxPython
> 2.8.7.1, binutils 20060817-1  and swig 1.3.31 it was fine. So unless
> you require 2.8.8.0 (or other combination) for some specific reason,
> this is the easiest workaround.
>
> Nagaraj
>
> On Sun, Jul 6, 2008 at 12:06 PM, Michael S. Grant <address@hidden>
> wrote:
>> -- Hello,
>>
>> After searching the mailing list archive, I'm looking for help with
>> wxPython 2.8.8.0 installation failures at step (9) of
>> http://www.gnuradio.org/trac/wiki/wxPythonCygwin.  (I'm using python 2.5
>> and swig 1.3.34).  The setup command is:
>>
>> python setup.py build_ext --inplace WXPORT=msw COMPILER=cygwin
>> BUILD_GLCANVAS=0 BUILD_GIZMOS=0 UNICODE=0
>>
>> The error message was an undefined reference building '_controls_'
>> extension:
>> g++ -mcygwin -shared -s
>> build/temp.cygwin-1.5.25-i686-2.5/src/msw/_controls_wrap.o
>> build/temp.cygwin-1.5.25-i686-2.5/src/msw/_controls_.def
>> -L/usr/local/lib
>> ...
>> undefined reference to `__imp___ZTV23wxDatePickerCtrlGeneric' ...
>>
>> followed by other similar errors and then:
>>
>> collect2: ld returned 1 exit status
>> error: command 'g++' failed with exit status 1
>>
>> Had the same failure multiple times on 2 different machines, so help on
>> this would be much appreciated!
>>
>> Michael
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> address@hidden
>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>
>