I'm a newbie. I received my hardware and trying test it. I started to test the USRP2 (last release of firmware) and FLEX900 with the "usrp2_fft.py". My system is Ubuntu 8.10 and the trunk version of gnuradio.
I'm trying this command:
#sudo usrp2_fft.py -f900M
But the graphic window of "USRP2 FFT" freezes and not responds anymore, so I need to kill the application. The spectrun don't show any communication at 900Mhz, even with many radios working in this frequency.
If I try run again (sudo usrp2_fft.py -f900M) the following error occurs:
"RuntimeError: Unable to retrieve daughterboard info"
So I need turn off and turn on the USRP2 to stop the error and run the "usrp2_fft.py -f900M" again.
What am I doing wrong?
Thank you!
[Prev in Thread]
Current Thread
[Next in Thread]
[Discuss-gnuradio] starting with usrp2_fft.py,
jeff .<=