[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Rev2 USRP and new RFX?
From: |
Joshua Lackey |
Subject: |
[Discuss-gnuradio] Rev2 USRP and new RFX? |
Date: |
Thu, 30 Apr 2009 00:49:42 -0400 |
User-agent: |
Mutt/1.4.2.2i |
Back in 2007 there was a discussion about using the newer RFX (mimo B)
boards with a Rev3 USRP.
It's pretty clear that the below applies to Rev2 boards as well but I
thought I would ask before I fire-up the old soldering iron.
Thanks!
On Wed, 07 Feb 2007 17:27:18 -0800 Matt Ettus wrote:
> All RFX boards currently shipping are configured for MIMO_B mode, which
> requires a Rev 4 or higher USRP (serial number greater than 500).
>
> If you wish to use it with a USRP with a serial number below 500 you
> will need to do the following:
>
> Remove R115 (zero ohms) and place it at R116
> Remove R36 (zero ohms) and place it at R34
> Put the RFX on a USRP (side A) and run the following:
>
> usrp/host/apps/burn-db-eeprom -f -A -t rfxYYYY_mimo_a
>
> where YYYY is the board you have (i.e. 400, 900, 1200, 1800,
> or 2400).
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] Rev2 USRP and new RFX?,
Joshua Lackey <=