[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Problem with Basic Tx-Rx Daughter Board
From: |
Eric Blossom |
Subject: |
Re: [Discuss-gnuradio] Problem with Basic Tx-Rx Daughter Board |
Date: |
Sun, 31 May 2009 19:59:53 -0700 |
User-agent: |
Mutt/1.5.18 (2008-05-17) |
On Sun, May 31, 2009 at 12:30:07PM -0700, Somya Ajmera wrote:
> Hi All, I am facing a small problem with my basic Tx-R daughter
> boards. I am trying to transmit and receive a simple Cosine waveform
> of 40 Mhz and Amp of 10 using GRC and trying to see the
> transmitted-received signal on to the oscilloscope While probing
> into the transmitter DBA connector, I can see the transmitted cosine
> waveform on to the scope, but when I connect the transmitter and
> receiver using a DBA to DBA connector (that is connecting the
> transmitter and receiver directly) and probe the receiver, I am not
> able to see the transmitted cosine wave, but instead I can see a 60
> Hz wave which I guess is the supply voltage freq, which remains even
> if I turn off my GRC . I tried to provide a ground using the ground
> pin (GND) on my Rx daughter board and also by different means but
> still face the same problem.
> Can anybody please help me to figure out this small issue.
>
> Thanks & Regards,
> Somya Ajmera
You'll need to tell us more to get any useful help.
http://gnuradio.org/trac/wiki/ReportingErrors
Eric