[Discuss-gnuradio] Operating Basic Rx after a trigger.

[Burak TUYSUZ]

Hi All,

At some part of a project, I need to count pulses coming from an external source and so to say after 100 pulses I want to start the operation of basicrx and save the data for 10 seconds. 
Then stop receiving, reset counter.

Can I use Basic Rx pins for this purpose?
Where can I get more information about how to operation of these pins?
Should I use c++ or python interface for this purpose? (I did some work in python, should I change them to c++)

Is there any similar project written before so I can reference?

Thank you in advance.

-Burak