Hi Matt,
I tried running ./usrp_nbfm_ptt.py -f 149.225e6 , the scope was
running, but the warning messages still show up as follows:
Warning: Treating daughterboard with invalid EEPROM contents as if it
were a "Basic Tx."
Warning: This is almost certainly wrong... Use appropriate
burn-*-eeprom utility.
audio_alsa_source[hw:0,0]: unable to support sampling rate 32000
card requested 44100 instead.
gr_fir_fff: using SSE
TX using Unknown (0x0052)
Warning: Treating daughterboard with invalid EEPROM contents as if it
were a "Basic Rx."
Warning: This is almost certainly wrong... Use appropriate
burn-*-eeprom utility.
RX using Unknown (0x0053)
Do I need to do anything with eeprom?