[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Power ,Bandwidth and spectrum switch problems
From: |
Eric Blossom |
Subject: |
Re: [Discuss-gnuradio] Power ,Bandwidth and spectrum switch problems |
Date: |
Wed, 30 Jun 2010 17:05:02 -0700 |
User-agent: |
Mutt/1.5.20 (2009-08-17) |
On Tue, Jun 29, 2010 at 11:23:36PM -0700, Johnson_lu wrote:
>
> Hi guys,
> Could anybody can help me for these problems?
> 1、I varied Tx_amplitude from 0.1 to 1 and measured the output with a
> spectrum analyzer. But the changes are very little. The output is almost the
> same when Tx_amplitude is 0.1 and 1. How can I reduce the transmit power to
> a very little value?
>
> 2、How do I know bandwidth of transmission and reception channels in
> tunnel.py?
>
> 3、I am using an USRP2 with Gnu Radio and XCVR2450 as daughterboard. I want
> to switch frequency among different channels 2.4G~2.5G. However, I find that
> switch only can succeed about 20 times, then fails.
> The python code is:
> self.tb.lock()
> ok = self.tb.txpath.set_freq(new_freq)
> if not ok:
> print "Failed to set Tx frequency"
> raise SystemExit
> ok = self.tb.rxpath.set_freq(new_freq)
> if not ok:
> print "Failed to set Rx frequency"
> raise SystemExit
> self.tb.unlock()
FWIW, there's no need to use lock/unlock to change the frequency.
You only need to use those when you are reconfiguring the topology of
the graph.
Try it without those and see if it works.
Eric