Hi,
I'm using USRP2 + WBX, with the SMA connector connected to the RX/TX
connector, and I've stuck a piece of wire about 7" long into the SMA connector.
However, when I run the following command, I get only static.
./usrp2_wfm_rcv.py -e eth2
Using RX d'board 0x0053
This daughterboard does not cover the required frequency range
for this application. Please use a BasicRX or TVRX daughterboard.
Press ENTER to continue anyway, or Ctrl-C to exit.
gr_fir_ccf: using SSE
gr_fir_fff: using SSE
aUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaUaU
The WBX has a range of 50MHz to 2.2GHz, so it does cover the frequency range.
What's it's dbid, so that I can add it to the script?
if not (dbid == 0x0001 or #usrp_dbid.BASIC_RX
dbid == 0x0003 or #usrp_dbid.TV_RX
dbid == 0x000c or #usrp_dbid.TV_RX_REV_2
dbid == 0x0040 or #usrp_dbid.TV_RX_REV_3
dbid == 0x0043 or #usrp_dbid.TV_RX_MIMO
dbid == 0x0044 or #usrp_dbid.TV_RX_REV_2_MIMO
dbid == 0x0045 or #usrp_dbid.TV_RX_REV_3_MIMO
dbid == 0x00??): #usrp_dbid.WBX
Elvis Dowson
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio