[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Measuring the noise floor of the BASIC_RX on USRP2.
From: |
Marcus D. Leech |
Subject: |
[Discuss-gnuradio] Measuring the noise floor of the BASIC_RX on USRP2. |
Date: |
Wed, 06 Oct 2010 02:26:04 -0400 |
User-agent: |
Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.1.12) Gecko/20100907 Fedora/3.0.7-1.fc12 Thunderbird/3.0.7 |
I did some experiments tonight, to check the sensitivity of the
BASIC_RX, to try to decide how much
gain I really need in front of it for one of my projects.
I have a signal at about -32dBm, and verified the pk-pk voltage on a good
oscilloscope, using a 50-ohm load in front of the scope, to make
certain that I was measuring
what the input circuit of the BASIC_RX would see. Then I plugged the
-32dBm signal into the
BASIC_RX/USRP2, and observed that at my selected bandwidth of
approximately 250KHz, the
FFT display had the wideband noise signal at -20dB. I then unplugged
the input from the BASIC_RX,
which should cause it to "see" the 50-ohm resistor that's across the
transformer input to the
BASIC_RX (at least, according to the schematics). The result was that
the output on the FFT display
dropped by 28db, giving an input noise level of around -60dbm with no
external signal. Now
granted, that resistor on the BASIC_RX input circuit (why is it
there?) will contribute roughly
-174dBm/Hz of noise, but that is *tiny* in this context.
Now, it's my understanding that the maximum power level capability of
the A/D is about 10dBm,
but one should perhaps back off from that by about 1dB or so. Doing
the "math" on the 14-bit
A/D resolution, you'd expect a noise floor around -75dBm or so, which
means that roughly
15dB of "bottom end" on the A/D is "missing" when plugged into a BASIC_RX.
Is this a correct analysis, or have I missed something somewhere in the
analysis?
Is there enough noise bumping around inside a USRP2 enclosure to
'stimulate' the lower
few bits of the A/D without anything connected?
--
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] Measuring the noise floor of the BASIC_RX on USRP2.,
Marcus D. Leech <=