[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] differences between USRP2 rev 3 and rev 4 boards
From: |
David Evans |
Subject: |
Re: [Discuss-gnuradio] differences between USRP2 rev 3 and rev 4 boards |
Date: |
Wed, 13 Oct 2010 09:16:45 -0700 (PDT) |
What's the push button for?
Dave
----- Original Message ----
From: Matt Ettus <address@hidden>
To: Steve Mcmahon <address@hidden>
Cc: GNR <address@hidden>
Sent: Tue, 12 October, 2010 23:16:23
Subject: Re: [Discuss-gnuradio] differences between USRP2 rev 3 and rev 4 boards
On 10/12/2010 02:22 PM, Steve Mcmahon wrote:
> I am wondering what are the differences between the USRP2 rev 3 board
> and the rev 4 board?
>
> I have one of each (one I ordered maybe a year ago and one I ordered
> this past summer), and I don't see any differences on the board
> itself. I understand that the versions of the FPGA image and the
> firmware that shipped on the SD card from the factory would be
> different, since over a year of time elapsed between my purchasing
> the two boards. But what else is different? I can't find a changelog
> for the USRP2 boards anywhere.
Some clocks were reorganized for layout reasons and the PPS input circuit was
modified to have a more consistent delay. The same FPGA image works for both.
Matt
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio