Re: [Discuss-gnuradio] UHD Announcement - December 13th 2010 - MIMO cable support

[Tobias Schmid]

Hey Josh,

thanks a lot. Now it works.
I'll try to implement algorithms soon.
But this should be a first step.

Am 14.12.2010 01:34, schrieb Josh Blum:
> Hello list,
>
> I would like to announce support for the MIMO cable with UHD. The
> support is experimental, so its not in the mainline yet, and is only
> available for USRP2 at the moment.
>
> The source for the FPGA code has not yet been pushed but you can get the
> pre-built images here:
> http://www.ettus.com/downloads/uhd_images/experimental/UHD-mimo-cable-support/
>
> The supporting host code is available on the packet_router branch of the
> uhd repo:
> http://code.ettus.com/redmine/ettus/projects/uhd/repository/show?rev=packet_router
>
> Here is an excerpt from the docs on the MIMO cable in UHD:
>
>    
> > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> > MIMO cable configuration
> > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> > Using the MIMO cable, two USRP devices can be grouped together in a 
> > multi-device configuration.
> > Only one device in the configuration can be attached to the ethernet.
> > This device will be referred to as the master, and the other device, the slave.
> >
> > * The master provides reference clock and time synchronization to the slave.
> > * All data passing between the host and the slave is routed over the MIMO cable.
> > * Both master and slave must have different IPv4 addresses but in the same 
> > subnet.
> > * The master and slave may be used individually or in a multi-device 
> > configuration.
> >      
> I hope that explains it. Feedback is welcome!
>
> Thanks,
> -Josh
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>