Re: [Discuss-gnuradio] can not connect USRP2 with UHD drivers

[Marcus D. Leech]

On 04/11/2011 08:34 PM, Abhijeet Mate wrote:

Hi Ron,

Thank you very much for your help. when i try to do ethtool eth0

Supported ports: [ TP MII ]

Supported link modes:   10baseT/Half 10baseT/Full 

                       100baseT/Half 100baseT/Full 

Supports auto-negotiation: Yes

Advertised link modes:  10baseT/Half 10baseT/Full 

                       100baseT/Half 100baseT/Full 

Advertised pause frame use: No

Advertised auto-negotiation: Yes

Link partner advertised link modes:  10baseT/Half 10baseT/Full 

                                    100baseT/Half 100baseT/Full 

Link partner advertised pause frame use: No

Link partner advertised auto-negotiation: Yes

Speed: 100Mb/s

Duplex: Full

Port: MII

PHYAD: 0

Transceiver: internal

Auto-negotiation: on

Supports Wake-on: pumbg

Wake-on: g

Current message level: 0x00000033 (51)

Link detected: yes

this is the output i get i have

 Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 02)

Ethernet driver.

how can i change it to gigabit. i tried it with

 sudo ethtool -s eth0 speed 1000 duplex full autoneg on

but it is not working.

Thanks,

Abhijeet. 

The RTL8101E chipset doesn't support Gigabit Ethernet.  No amount of asking it nicely using
  ethtool can change that.

-- 
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org