On Fri, Apr 6, 2012 at 1:39 PM, sibar002
<address@hidden> wrote:
Hello,
I am using USRP 1 with the XCVR2450 daughterboard. I am also using Ubuntu
10.0.4 with gnuradio-3.5.1. I have tried running benchmark_tx/rx with the
following parameters:
./benchmark_tx.py -f 2.45G -A J1 --spec B:0
./benchmark_rx.py -f 2.45G -A J1 --spec B:0
I am not consistently able to receive the packets that are sent. I sometimes
receive the initial packets, but then program begins to overflow ('O'). I
have tried connecting the USRP1s directly with attenuators, and I have also
tried using the antennas. I have also used the uhd_fft.py program in order
to make sure that I am receiving a signal. I am able to see a peak at the
correct frequency when I am transmitting. I have also tried using the
Basic_Tx/RX and LFTX/RX daughter-board and I obtain the same result. I would
greatly appreciate any help or advise that anyone could give me. Thank you
for your time and help.
Sam
--
View this message in context: http://old.nabble.com/Benchmark_Tx-Problem-tp33645086p33645086.html
Sent from the GnuRadio mailing list archive at Nabble.com.
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio