[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] USRP receive issues
From: |
Rob Rhinehart |
Subject: |
[Discuss-gnuradio] USRP receive issues |
Date: |
Wed, 4 Jul 2012 01:19:04 -0700 |
Hello,
I have a straightforward setup using gnuradio and a USRP B100 to transmit CW to an E100 (SBX and WBX daughterboards, respectively). I have verified the RF output of the B100 with a spectrum analyzer and the receive capability of the E100 with a signal generator, but when I connect the two directly with coax I see a strange pattern on the receiver FFT (see attachment), when I'm expecting a spike at the center frequency. The receive window only shows 1MHz of bandwidth but I've looked at the spectrum around the center frequency and the spike is nowhere to be found. My sample rates are 500k
Has anyone else seen this before? Suggestions would be very welcome.
Thank you!
Rob
usrp_tx_rx.png
Description: PNG image
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] USRP receive issues,
Rob Rhinehart <=