[Discuss-gnuradio] siggen.py transmission Error

[Abbasi]

i m trying to transmit simple sin wave to check my usrp transmission
reception .
when i run usrp_siggen.py -f 900M  --> " Using TX d'board A: <none> " is
displayed on terminal.
when i run usrp_fft.py -f 900M  --> Failed to set RF initial frequency is
displayed in " FFT GUI "+ " u0u0u0u0..... " is displayed in terminal.

i m using gnu radio 3.2.2 
USRP1
D.Boards Flex900.
fujitsu core i7 (as i have read that u0u0u0u0 is due to low performance P.C
)
Need Your Help plz.

Regards
Bilal Nasir.

 

-- 
View this message in context: 
http://old.nabble.com/siggen.py-transmission-Error-tp34199166p34199166.html
Sent from the GnuRadio mailing list archive at Nabble.com.