Re: [Discuss-gnuradio] PCB Log Periodic Antenna connection

[Dincer Beken]

Thank you Marcus,

 

but I have still the following questions:

 

Can I connect the Antenna then with the SMA-M/SMA-M cable to the daughterboard RX antenna port?

 

What kind of a stand should I use?

 

Can I put the Antenna onto the (plastic) GROUND PLANE (used against ESD)?

 

This is a bonus question:

Is it enough, that the antenna stands up? Does the SMA cable need to have a specific degree of bending?

 

Regards,

Dincer

Von: discuss-gnuradio-bounces+address@hidden [mailto:discuss-gnuradio-bounces+address@hiddenrg] Im Auftrag von Marcus D. Leech
Gesendet: Freitag, 27. September 2013 16:55
An: address@hidden
Betreff: Re: [Discuss-gnuradio] PCB Log Periodic Antenna connection

 

On 09/27/2013 10:52 AM, Dincer Beken wrote:

Hi again,

 

Just to be clear,

do I just need to solder the legs of the small SMA connector with the holes in the PCB Log Antenna?

Just as much that it can barely hold?

 

Regards,

 

The legs and the center conductor need to be soldered.

-- 

Marcus Leech

Principal Investigator

Shirleys Bay Radio Astronomy Consortium

http://www.sbrac.org