[Discuss-gnuradio] setup of usrp N100/N200

[Sandhya G]

HI all,

I have followed as per the instructions given in the webpage for set up of the Usrp N200/N210 but still i am unable to communicate between the  hardware and host pc

 

                1.I have set the static ip of the host pc to 192.168.10.1(ifconfig eth0 192.168.10.1).

2.Whenever i give the device address=addr=192.168.10.1 and run the grc i am getting the error has “unknown key format” 

3.Whenever i ping 192.168.10.2 or use the command  uhb_find_device  i am getting warning as “NO DEVICE FOUND “

4. Is that a must i have to upload the fpga and firmware images when using the device for the first time.

5.Sometimes i am getting an error like” unable to find as single device”.

6.The host pc is supporting only 10/100MBPS .Is that the only problem so that i am unable to communicate with the hardware.

 

Can anybody help me on this issue.Awaiting for your valuable reply

Thanks in advance 

Sandhya.G