discuss-gnuradio
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[Discuss-gnuradio] Questions about benchmark_tx/bench mark_rx with USRP
From
:
Nasi
Subject
:
[Discuss-gnuradio] Questions about benchmark_tx/bench mark_rx with USRP N200 & GNU 3.7
Date
:
Thu, 05 Dec 2013 22:56:13 +0400
Dear All,
I am trying to transmit something and receive it back using the second USRP N200 device.
However it fails, or I did not do it correctly.
I have two laptops and two (USRP N200, XCRV2450 db, 2 vert2450 antennas for each)s.
GNURADIO v3.7 is installed to Ubuntu 13.04.
I run in the first laptop this command:
sudo ./benchmark_tx.py -f 2.45G -A J1 --spec A:0
In the second one I run this:
sudo ./benchmark_rx.py -f 2.45G -A J1 --spec A:0 --snr 10
But gives me:
TIMEOUT
TIMEOUT
I changed the sampling rates also did not work.
I played with the frequency also did not work.
What can cause this?
Is this a hardware problem?
--
NE
reply via email to
[Prev in Thread]
Current Thread
[Next in Thread]
[Discuss-gnuradio] Questions about benchmark_tx/bench mark_rx with USRP N200 & GNU 3.7
,
Nasi
<=
Prev by Date:
[Discuss-gnuradio] GRC Working Group Call
Next by Date:
Re: [Discuss-gnuradio] gr-ieee802-11: connecting two usrp devices
Previous by thread:
[Discuss-gnuradio] GRC Working Group Call
Next by thread:
[Discuss-gnuradio] Problem using FFT-class in my own written block (part II)
Index(es):
Date
Thread