[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Minimum amount of data to trigger WX GUI Scope Sink?
From: |
David Halls |
Subject: |
[Discuss-gnuradio] Minimum amount of data to trigger WX GUI Scope Sink? and Ch 1 vs. Ch2 with Ch 3 vs. Ch 4 |
Date: |
Wed, 11 Dec 2013 18:53:06 +0000 |
Hi,
I am using WX GUI Scope Sink, and I have set the sample rate = 1M, same as the USRP. It seems that a minimum number of data points are required before anything appears on the plot - is that correct, and how can it be adjusted?
Also, I am looking at constellations, using the XY mode to show real and imaginary. It is possible to have multiple inputs, but is it possible to view multiple 'series' in XY mode?
I seem to be only able to choose Ch X vs Ch Y, e.g. Ch 1 vs. Ch 2 ( Re(in1) vs. Im(in1) ) or Ch 1 vs. Ch 4 (Re(in1) vs. Im(in2)). I would like to see Ch 1 vs. Ch 2 and Ch 3 vs Ch 4 simultaneously?
Thanks in advance! :)
David
NOTE: The information in this email and any attachments may be confidential and/or legally privileged. This message may be read, copied and used only by the intended recipient. If you are not the intended recipient, please destroy this message, delete any copies
held on your system and notify the sender immediately.
Toshiba Research Europe Limited, registered in England and Wales (2519556). Registered Office 208 Cambridge Science Park, Milton Road, Cambridge CB4 0GZ, England. Web: www.toshiba.eu/research/trl
Scanned by MailDefender - managed email security from intY - www.maildefender.net
- [Discuss-gnuradio] Minimum amount of data to trigger WX GUI Scope Sink? and Ch 1 vs. Ch2 with Ch 3 vs. Ch 4,
David Halls <=