Re: [Discuss-gnuradio] How to set a master clock rate on USRP B200

[raf raf]

Thank you,

In GRC, I changed Clock Rate (Hz) by giving a value of 28e6 and it works now. 

---

Date: Sun, 25 May 2014 23:41:01 -0400
From: address@hidden
To: address@hidden
CC: address@hidden; address@hidden
Subject: Re: [Discuss-gnuradio] How to set a master clock rate on USRP B200

On 05/25/2014 11:39 PM, jason sam wrote:

"device args" parameter is not in the UHD USRP source/sink block?There is only 'Device addr'

Sorry, I meant Device Addr

On Fri, May 23, 2014 at 9:39 PM, Marcus D. Leech <address@hidden> wrote:

On 05/23/2014 12:23 PM, raf raf wrote:

Hello All Gnu Radio user, 

To use a 2 TX, I want to change a clock rate to an accepted one, under 30.72 MHz. I use the API with uhd_usrp_probe and it works only for this command. Can you give me the idea or python code to use this argument parameter with a python flowgraph?

 --args="master_clock_rate=28"

Thanks. 

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

In GRC, where it has a "device args" parameter, that's wher this master_clock_rate=28e6  should go.  I assume you meant 28e6, rather than 28.
  Everything is in Hz, and there's no way the B200 can go down to a clock rate of 28Hz.

-- 
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio