Ali,
you need to be a little more proactive when trying to solve your
problems. As you have showed in other posts, you're able to run
programs from a command line (e.g. cmake), and that's what you
should do here.
Greetings,
Marcus
On 05.06.2014 10:29, jason sam wrote:
The problem is that when i run it in terminal the terminal opens
momentarily and then closes again.
On Thu, Jun 5, 2014 at 1:14 PM, Marcus Müller <address@hidden>
wrote:
Hi Ali,
well, then what's the problem when running the Python file in a terminal?
Usually, this will be something like your audio device being
inaccessible and is really more of a configuration problem on your side :)
Greetings,
Marcus
On 05.06.2014 09:59, jason sam wrote:
'.grc' file is not available,only '.py' is available.
On Thu, Jun 5, 2014 at 12:56 PM, jason sam <address@hidden> wrote:
If i run it in terminal even then its not running.
On Thu, Jun 5, 2014 at 12:52 PM, Martin Braun <address@hidden>
wrote:
On 05.06.2014 06:28, jason sam wrote:
Hi All,
When i try to run any of built in examples (in .py form) with GRC,i
get
the following error:
Are you trying to open the .py file with GRC? If yes, you can't do
that.
You must either run the .py directly, or run the .grc file.
M
Error:
/usr/local/share/gnuradio/examples/audio/audio_fft.py:1:
1:FATAL:PARSER:ERR_DOCUMENT_EMPTY:
Start tag expected, '<' not found
An example of such file is as attached.
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
|