Re: [Discuss-gnuradio] UHD Driver Not Working

[Activecat]

On Tue, Jun 17, 2014 at 2:25 AM, Carl Condas <address@hidden> wrote:

An attempt to use PyBOMBS to install GNU Radio resulted in no errors. However, the UHD driver must have installed incorrectly, because the source and sink blocks are not working. Is there any way to fix this problem?

-Carl

I guess you are not installing on Ubuntu Linux.
I experienced the same problem [1] when using PyBOMBS to install gnuradio on Debian Wheezy.

Nevertheless the link below may worth referred.

In short, you may try these in sequence:

a).  Run "./pybombs env" and then "source ../target/setup_env.sh"

b).  Search for "uhd_usrp_source.xml" and make sure that this is in your GRC path

c).  Manually remove all ghost version of uhd and reinstall it using pybombs.

1.  http://gnuradio.4.n7.nabble.com/PyBOMBS-installed-gnuradio-uhd-usrp-sink-not-found-td48388.html