Re: [Discuss-gnuradio] Detecting unipolar and repeating preamble on wired communications?

[Jeon]

Dear, Sylvain Munaut,

Thanks.I got a hint from your answer.

What about using moving average instead LPF?

I think moving average (MA) is much simpler than LPF if computational cost is considered.

But, another issue is, precision on estimation A and A/2. In that case, LPF would be better.

Anyway, I will do applying either LPF and MA on my flow graph. Thanks.

Regards,

Jeon.

2015-05-05 16:27 GMT+09:00 Sylvain Munaut <address@hidden>:

Hi,

> (Bipolar: a signal swings between +A volts (or amperes) and -A volts;
> Ethernet, USB, Wi-Fi, ... are using bipolar signals,
> Unipolar: a signal swings between +A volts and 0 volts)

There is no difference ... "0 volt" is just an arbitrary reference point.

0 <-> +A swing is the same as
-A/2 <-> A/2 swing if you shift your reference ...

Ethernet and USB are _differential_ but that's just to improve signal
integrity / noise immunity and such. At the receiver end, the
differential input buffer essentially compares both and see which one
is higher. (a bit simplified, but that's the gist of it).

> Is there anyone already implemented unipolar preamble detection
> succesffully, or could anyone give me some hints on mathematical approach or
> something?

If 'A' is known, just remove -A/2 from your input signal.
If it is unknown,you can use a very long time constant low pass to
find it. (assuming your signal doesn't have long runs of 0 or 1).

Cheers,

   Sylvain

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio