Re: [Discuss-gnuradio] pybombs difficulty

[lwashbo]

Mike,

When I ran into this problem, I had to reinstall pybombs. I think the problem 
lies in changing the installation prefix after installing pybombs.

I'm sure there is another way to fix this, I just don't know what it is.

When I reinstalled pybombs, I defined the installation prefix when the several 
prompts are asked at the beginning.

Sent from my Cyanogen phone

On Aug 3, 2015 4:39 PM, Mike Markowski <address@hidden> wrote:
>
> I use gentoo at home and have no difficulty keeping gnuradio up to date.
>
> At work we're on a standalone network (no internet) so occasionally bring 
> computers home to update them.  Lately, I've been having trouble with 
> pybombs.  Using a freshly installed ubuntu 15.04, then doing an 
>
>   apt-get update
>   apt-get upgrade [not sure the update was necessary]
>
> I first used
>
>   apt-get install gnuradio
>
> Thinking better of it, I ran
>
>   apt-get remove gnuradio
>   apt-get autoremove
>
> Then went with pybombs
>
>   git clone git://github.com/pybombs/pybombs
>   cd pybombs
>   ./pybombs config [use install path /usr/local/gnuradio]
>   ./pybombs install gnuradio
>
> And after several tries continue to receive this error:
>
> [...many lines of install...]
> Unpacking liblog4cpp5-dev (1.0-4) ...
> Setting up liblog4cpp5-dev (1.0-4) ...
> installation ok via: deb
> Installing from source: gnuradio
> Cloning into 'gnuradio'...
> Checking connectivity... done.
> Cloning into 'volk'...
> remote: Counting objects: 5450, done.
> remote: Compressing objects: 100% (10/10), done.
> remote: Total 5450 (delta 2), reused 0 (delta 0), pack-reused 5440
> Receiving objects: 100% (5450/5450), 1.54 MiB | 0 bytes/s, done.
> Resolving deltas: 100% (3918/3918), done.
> Checking connectivity... done.
>  
>     CC=gcc CXX=g++ cmake .. -DCMAKE_BUILD_TYPE=RelWithDebInfo 
> -DCMAKE_INSTALL_PREFIX=/usr/local/gnuradio  -DENABLE_DOXYGEN=OFF 
>
> Configuring: (100%) 
> [==========================================================]
> Configuration failed. Re-trying with higher verbosity.
> make: *** No targets specified and no makefile found.  Stop.
> Build failed. See output above for error messages.
>
> Any hints as to what is going wrong?
>
> Thanks,
> Mike