|
From: | Saulo Queiroz |
Subject: | Re: [Discuss-gnuradio] Gnuradio 802.11g |
Date: | Tue, 12 Jan 2016 17:01:21 +0000 |
Well, if you implement a lot of the IEEE802.11 in the FPGA, yes, that could work. But: then it would hardly be a GNU Radio implementation.
Also, please don't expect the poor CPU of the E310 to process 20MHz of bandwidth itself; it's a power-efficient ARM, and you'll need a relatively new PC CPU to run things like FFTs at that rate.
Best regards,
Marcus
On 12.01.2016 17:40, Gabriel Pechiarovich wrote:
Hi thank you for the reply.I have acces to the USRP E310, is it posible that this hardware will support the correct timings using the RFNoC?
2016-01-08 12:59 GMT-05:00 Saulo Queiroz <address@hidden>:
hardware, you can get that with RFNoC module from Ettus, but with hard work.the work of critical time operations like csma count down. Depend on yourHi Gabriel,No. In most of boards, the delay between PC and device turns unfeasible
On 8 January 2016 at 17:45, Gabriel Pechiarovich <address@hidden> wrote:
_______________________________________________HiIs there any fully working implementation for the 802.11g protocol in gnuradio capable of working as an access point?
I was wondering if there exist one with the MAc layer fully developed, since i've only seen simplyfied MAC layers, or is there a software/hardware limitation.
Thanks in advance------------------------------------
Gabriel Pechiarovich Salas
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
--
Saulo Jorge bq
- "Beware of bugs in the above code; I have only proved it correct, not tried it."Donald Knuth.
--
Gabriel Pechiarovich SalasRed Dragon GamesDesigners and game developers
_______________________________________________ Discuss-gnuradio mailing list address@hidden https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |