Re: [Discuss-gnuradio] USRP2 + WBX: Half Duplex

[Marcus D. Leech]

On 02/26/2016 07:00 AM, Alex Weihkopf wrote:

Hello,

 

I am using two USRP2 + WBX connected via cable on the TX/RX antenna ports. I want to use them for my GNURadio OFDM-project in half-duplex mode.

 

Problem: Whenever I send a data-packet (~10ms) on the TX-chain of one USRP2, I receive the same packet on the RX-chain of the same USRP2. The transmitter receives its own packets.

 

Why is that? Insufficient Decoupling between Receive and Transmit Circuit?

 

Does the USRP2 internally turn off the Receive Circuit when the Transmit Circuit has data to send? Or does it just disconnect the Receive Circuit from the antenna?

 

Is there a comprehensible GNURadio example for USRP2 + WBX in half-duplex-mode?

 

Regards,

Alex

 

 

 

The RX chain is not disabled, only switched-away from the TX/RX antenna.  There's about 40+dB of isolation between the two sides,
  but that still produces a fair amount of signal at the RX.  The best way forward is to simply ignore RX traffic while you're TXing.