|
From: | Pranav Padalkar |
Subject: | Re: [Discuss-gnuradio] Full Duplex operation, time synchronization and self interference cancellation |
Date: | Mon, 12 Sep 2016 07:44:10 +0000 |
Good morning,
Can anyone help me with this? I don't want to use the packet structure as shown in the OFDM example. But I want to use the carrier_allocator and other blocks, and later also perform synchronization of the OFDM signal received.
Thanks and regards,
Pranav Padalkar
Fraunhofer-Institut für Eingebettete Systeme und Kommunikationstechnik ESK
From: Discuss-gnuradio <discuss-gnuradio-bounces+address@hidden> on behalf of Pranav Padalkar <address@hidden>
Sent: Thursday, September 8, 2016 1:42 PM To: address@hidden Subject: [Discuss-gnuradio] Full Duplex operation, time synchronization and self interference cancellation Hello all,
I am trying to design a full duplex operation on my USRP3. I have to use OFDM and a defined TDMA scheme for different OFDM symbols. I also have to use a preamble, but it has to be sent once every TDMA frame. I have designed a block which takes care of my TDMA and preamble implementation. Basically, I cannot use packet structure (as given in the OFDM examples). On the transmitter side I am using OFDM carrier allocator, IFFT and OFDM cyclic prefixer(CP).
Since, it has to be full duplex system, on the receiver side I want to perform the synchronization of my received signal with the transmitted signal, and then after removing CP and performing FFT, I have to subtract my received signal from the transmitted signal. I tried to understand the corr_est and corr_sync blocks by going through their examples. But I am not able to understand how can I get the value of offset (after synchronization), so that using that offset value I can shift my TX signal and subtract the RX signal.
I request if some one can point me in the right direction.
Thanks and Regards,
Pranav Padalkar
Fraunhofer-Institut für Eingebettete Systeme und Kommunikationstechnik ESK
|
[Prev in Thread] | Current Thread | [Next in Thread] |