|
From: | Nikita Airee |
Subject: | Re: [Discuss-gnuradio] gr-ieee802-11 tx and rx |
Date: | Tue, 22 Nov 2016 15:53:29 +0530 |
Hi,Maybe you find something useful here:On 21 Nov 2016, at 11:34, Nikita Airee <address@hidden> wrote:Setup consists of 2 usrp 2953R (X310) connected via SMA and 30 dB attenuator at the Rx end.The problem I'm facing is that the packets that are sent do not get decoded at the reciever for high sample rates of 10 and 20Msa/s.On enabling debugging of Decode Mac block I get 2 distinct messages which indicate where the error is:
- checksum wrong -- dropping
- Warning: starting to receive new frame before old frame was complete
The second warning sounds like there could be a DC component (i.e. a signal with a high autocorrelation) that triggers frame detection all the time. This might totally overflow the receiver.You could send some 0s at the transmitter and check if already that triggers frame detection (use the Log/Debug option of the Sync Short block).Also assert that there are no over/underruns. If frame detection works as expected you could try volk_profile to optimize performance.Best,Bastian
[Prev in Thread] | Current Thread | [Next in Thread] |