Re: [Discuss-gnuradio] gnuradio-companion binary not getting installed

[Philip Balister]

I think you need a python-devel package installed. Exact name will be
distro dependent.

Philip

On 11/29/2016 09:34 AM, Jason Matusiak wrote:
> This was really good information Seth, thanks.  I tried the steps
> Nicolas previously mentioned and I had the same problem.  I ran your
> commands and I see gnuradio-companion under the "disabled components" list.
> 
> Looking further up in the output, the thing I see different from your
> list is that I see:
> Dependency ENABLE_PYTHON = OFF
> 
> Why would that be?
> 
> Thanks!
> 
> On 11/28/2016 04:58 PM, Seth Hitefield wrote:
>> Something may have disabled gnuradio-companion in cmake.
>> Can you run: *"cd ~/gnuradio/src/gnuradio/build; cmake .."*?
>>
>> Towards the end of the output you should see:
>>
>> -- ######################################################
>> -- # Gnuradio enabled components
>> -- ######################################################
>>
>> and
>>
>> -- ######################################################
>> -- # Gnuradio disabled components
>> -- ######################################################
>>
>> Which one does gnuradio-companion fall under?
>>
>> You can also check the cmake output for the section where
>> gnuradio-companion is being configured.
>> That will give you an idea of what is going wrong if it is disabled.
>> It should look something like this:
>>
>> -- Configuring gnuradio-companion support...
>> --   Dependency ENABLE_GNURADIO_RUNTIME = ON
>> --   Dependency ENABLE_PYTHON = ON
>> --   Dependency PYTHON_MIN_VER_FOUND = TRUE
>> --   Dependency CHEETAH_FOUND = TRUE
>> --   Dependency LXML_FOUND = TRUE
>> --   Dependency PYGTK_FOUND = TRUE
>> --   Dependency NUMPY_FOUND = TRUE
>> --   Enabling gnuradio-companion support.
>> --   Override with -DENABLE_GRC=ON/OFF
>>
>> -- Seth
>>
>>
>> On 11/28/2016 12:57 PM, Jason Matusiak wrote:
>>> I have a fresh install of Ubuntu 14.04 on a tablet and am trying to
>>> install gnuradio via pybombs.  I run "pybombs prefix init ~/gnuradio
>>> -a myprefix -R gnuradio-default" and it seems to complete
>>> successfully.  But if I look into gnuradio/bin, there is no
>>> gnuradio-companion.  Because of that, when I source setup_env.sh and
>>> tab out "gnur", the only thing that auto-completes is
>>> gnuradio-config-info.
>>>
>>> Any idea why the pybombs install acts like it worked, but I don't
>>> have a binary to run?
>>>
>>> _______________________________________________
>>> Discuss-gnuradio mailing list
>>> address@hidden
>>> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>
> 
> 
> 
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>